Ask a question

281 questions

326 answers


3156 members

Ask a question
0 votes
in Smart Autonomous Solutions by
For our application, we need to detect harsh acceleration and braking. However, this is intended to be used on vehicles not travelling at a speed of more than 20kmph.

On reading the manual, I realised that the shock detection feature can be activated only above the speed of 20kmph. Is there any way to configure the TFT100 for our use case?

Any help is appreciated. Thanks!

1 Answer

0 votes

The TFT100 device Accelerometer Calibration has been tested with lower speeds and the new bare minimum is 7KMH (Around 4.3MPH).

You can check the updated information on the dedicated wiki page:

This means that using the Crash Detection feature is also possible at the previously mentioned speed.

Best regards,