Ask a question

321 questions

404 answers

306 comments

6426 members

Ask a question
0 votes
127 views
in Smart Autonomous Solutions by

TFT 100 FW 55.0.8_12 -> 55.0.9_8 (2004/1/1 0:26) RST:2 2021/7/28 21:50=2,2; 2021/4/30 18:56=5,255;

 I have a project for forklift tracking, because of this I suggested the TFT 100 device which is specialized for this type of equipment.

For my project it is very important to have information on harsh acceleration, braking and turns and the crash detection.

I configured everything according to the manual, however, reading the accelerometer automatic calibration instructions says that the speed must be greater than or equal to 20 km / hr. The equipment I have cannot reach speeds greater than 10 km / hr.

 

What can I do to calibrate the accelerometer?

Device name: TFT100

Firmware version: 55.00.09

Firmware revision: 12

GNSS version: AXN_5.10_3333

Accelerometer. Available values:0

0:Kx023

1:Lis3DH

2:Lis2DH

3:KxG03

4:DA217

1 Answer

0 votes
by

Everything seems to be in order in the handbook, but reading the accelerometer automated calibration instructions, the speed must be more than or equal to 20 km/hr.

play tic tac toe

by

That's the problem, forklifts don't run faster than 10 km/hr. Therefore it will never be possible to calibrate the accelerometer automatically.

It should automatically calibrate at lower speeds